Removing and Installing Replacement Transmission (A5S 360R/390R)

24 00 048 - Removing and installing replacement transmission (A5S 360R / 390R)





Drain automatic transmission fluid at oil drain plug.
Tightening torque 24 11 6AZ Transmission Housing, Transmission Oil Sump.





Recycling:
Catch and dispose of emerging transmission fluid.
Observe country-specific waste-disposal regulations





Important!
- Before installing replacement transmission, always flush transmission fluid cooler together with lines Flushing Transmission Oil Cooler with Lines (Automatic Transmission).
- After completion of work, check transmission fluid level Procedures.
- Use only the approved transmission fluid.
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Replacement transmission is supplied filled with transmission fluid.





Necessary preliminary tasks:
- Remove transfer box Removing And Installing Transfer Case (ATC 400 X-Drive).
- Remove automatic transmission Removing and Installing Automatic Transmission (A5S 360R/390R).





Convert selector lever (2).
Tightening torque 24 51 1AZ.
Convert holder (3) for cable.





Convert transportation lock (1).
Convert all cable holders.
Convert all seal plugs.
Convert protective cap on output shaft.

Important!
After removing transportation lock, secure torque converter against slipping out.

Transmission identification:

- refer to BMW Parts Service
- on type plate