Installing Replacement Transmission (GS6-37BZ/DZ)

23 00 036 - Installing replacement transmission (GS6-37BZ/DZ)





Important!
After completion of work, check transmission fluid level Procedures.
Use only the approved transmission fluid.

Failure to comply with this instruction will result in serious damage to the transmission.





Recycling:
Catch and dispose of escaping transmission fluid.
Observe country-specific waste-disposal regulations





Necessary preliminary tasks:
- Drain gear oil Procedures at oil drain plug.

Tightening torque:23 00 4AZ Transmission in General.

- Remove transmission Removing and Installing Transmission (GS6-37BZ).

- Remove transfer box Removing And Installing Transfer Case (ATC 400 X-Drive).





Convert following parts from previous transmission to new transmission.
- Release bearing and release lever Service and Repair.

- Ball pin and spring wire clip.

- Studs for clutch slave cylinder.

- Reversing light switch, tightening torque: 23 11 1AZ [1][2]Electrical Fittings.





Convert shift rod joint.
Push back retaining ring (1) and drive out dowel pin (2).





Note:
Check damping disk (6) for damage and replace if necessary.





Add final details to vehicle.
Check oil level.

Installation Note:
Observe greasing specification Removing and Installing Transmission (GS6-37BZ).