Replacing A Rear Pulse Generator
Replacing A Rear Pulse GeneratorCaution:
Read and comply with General Information.
Remove rear wheel.
Pull plug connection (1) out of mounting and disconnect.
Installation:
Ensure proper locking of plug connector.
Pull cable with rubber grommets out of brackets and open cable ties.
Installation: Ensure proper seating of rubber grommets and proper routing of impulse sensor cable.
Release hexagon socket head cap screws (1), pull pulse generator (2) out of bore.
Installation:
Clean hole for impulse sensor and grease with lubricating grease Staburags NBU 1 2/K
- Pulse generator to swivel bearing/wheel carrier 8 Nm