Removing and Installing/Replacing Interior Rearview Mirror (With "X" Cable and Plug Trim Cover)

51 16 060 Removing And Installing/Replacing Interior Rearview Mirror (with "X" Cable And Plug Trim Cover)

IMPORTANT:
- Work may only be carried out at a room/object temperature of 18 ... 28 °C.
- If this cannot be guaranteed (cold/hot countries), it is necessary to equalize the temperature of the windscreen, mirror foot and rearview mirror (e.g. car left to stand indoors or in the shade for at least 30 minutes).

Version with remote control for central locking:
If necessary, disconnect negative lead from battery.

Version with compass:
Check compass function if replacing or after disconnecting interior mirror plug connection or battery.
If necessary, calibrate compass in interior rearview mirror.

IMPORTANT:
- To avoid breaking windscreen:
- Snap out (press) rearview mirror only in direction of travel towards windscreen.
- Do not under any circumstances twist the mirror foot when removing.
- Twisting the mirror off the mirror mount will damage the rear catch.
- If the rear catch is damaged, the mirror will be loose when installed and must be replaced.







Lever out plug trim cover in direction of arrow and disconnect plug connection underneath.







IMPORTANT:
- Risk of damage.
- Do not pull off rearview mirror (1) from windscreen against direction of travel and or snap out by turning.

Snap out interior mirror (1) from mirror mount (2) towards front with increasing pressure (not abruptly) and remove.







Installation:
1. Twist mirror foot by approx. 45° and fit to mirror mount.
2. Turn mirror foot until it engages on mirror base.

Only replace with version with remote control for central locking:
Initialize all transmitters (ignition keys), refer to Owner's Handbook.