Sunroof / Moonroof: Adjustments

54 10 004 - Adjusting glass tilt sunroof lid





Special tools required:
- 00 9 315 00 9 310 Assembly Wedges (Set in Plastic Case)
- 00 9 341





Necessary preliminary tasks:
- Remove gaiter Service and Repair on left and right
- Close glass tilt sunroof lid completely
- Check glass tilt sunroof for correct adjustment
Gap adjustment only:
- Remove roofliner 51 44 005 - Removing and installing/replacing roofliner (version without glass tilt sunroof)
If the glass tilt sunroof is outside the adjustment tolerances, adjust as follows:





Height adjustment:
Carry out the following step on one side first and then the other (left, right or vice versa):
- Slacken Torx screws (1) on left/right so that sunroof lid (2) can still just be adjusted.
- Move sunroof lid as required.
- Make sure all screws are tightened down.
- Tightening torque 54 10 5AZ 54 10 Glass Tilt Sunroof.
- Repeat work steps on the other side.





Checking height:
Check height of glass lid (1) in relation to body (2) with special tool 00 9 315 00 9 310 Assembly Wedges (Set in Plastic Case).
Press glass lid (1) at front and rear towards top or bottom until ideal position is reached.
Height:
- Front - glass lid flush to 2 mm lower
- Rear - glass lid flush to 2 mm higher
Check function and adjustment.





Gap adjustment:
- Slacken Torx screws (1) so that sunroof lid (2) can still just be adjusted.
- Move sunroof lid as required.
- Make sure all screws are tightened down.
- Tightening torque 54 10 5AZ 54 10 Glass Tilt Sunroof.





Checking gap:
Check same gap (A) in relation to body with special tool 00 9 341.
Slide special tool 00 9 341 or similar between seal and insert. It must be possible to slide the card against the same level of resistance.
Slide glass lid towards front or rear until ideal position is reached.