Removing and Installing/Replacing Main Mount For Convertible Top

54 31 017 Removing And Installing/Replacing Main Mount For Convertible Top

Necessary preliminary tasks:
- Remove convertible top







Only on right side:
Disconnect cable tie (1), release screw (2), if necessary raise convertible top (4) slightly and remove micro-switch (3) towards top.

NOTE: Further information in MG 61







Release pins (1 and 2) and remove.
Unscrew bolt (3).
14AZ Convertible top frame to main bearing
M6 11 Nm







Unclip cover.
Mark position of screw heads (1).







Release screws and remove main mount.

Replacement only:
Screw (1) must be replaced and is supplied with range of space parts.

Installation:
Fit thin spacer between bracket and frame.
Return screws to original position.
Tighten down bolts.
12AZ Main bearing to convertible top frame (B-pillar)
M8 17 Nm







Replacement only:
- Release screws (1) and remove spacers (2).
- If necessary, release screw (3) and remove hardtop mounting (4).