Installing Replacement Transmission (GS6-53BZ/DZ) AWD

23 00 037 - Installing replacement transmission (GS6-53BZ/DZ) AWD





Important!
After completion of work, check transmission oil level Procedures.
Use only the approved transmission fluid.

Failure to comply with this instruction will result in serious damage to the transmission.





Recycling:
Catch and dispose of escaping transmission fluid.
Observe country-specific waste-disposal regulations





Necessary preliminary tasks:
- Drain gear oil at oil drain plug. Tightening torque:23 00 4AZ Transmission in General

- Remove gearbox Removing and Installing Transmission (GS6-53DZ) N54 AWD

- Remove transfer box Removing and Installing Transfer Case (ATC 300)





Release screws.
Remove and convert transmission bearing block.
Tightening torque 22 32 2AZ 22 32 Transmission Mounts.

Note:
Illustration shows E46.





Convert shift rod joint.
Push back retaining ring (1) and drive out dowel pin (2).





Note:
Check damping disk (6) for damage and replace if necessary.





Convert following parts from previous transmission to new transmission.
- Release bearing and release lever Service and Repair.

- Ball pin and spring wire clip

- Studs for clutch slave cylinder.

- Reversing light switch tightening torque: 23 41 5AZ [1][2]Automatically Shifted Manual Transmission/Transaxle.





Add final details to vehicle.
Check oil level.

Installation Note:
Observe greasing specification.