Removing and Installing Complete Rear Left or Right Power Window Unit

51 37 000 - Removing and installing complete rear left or right power window unit





Necessary preliminary tasks:
- Remove rear door window glass Replacing Rear Left or Right Door Window





Slacken screws (1 and 2) (do not release).
Remove clamp (3) in direction of arrow.
Tightening torque 51 35 2AZ [1][2]Rear Door Window Motor.





Installation:
Make sure guide (1) is correctly seated when fitting clamp (2).





Release screw on power window unit (2) through bore (1).
Disconnect plug connection (3) from drive (4).
Feed power window unit (2) in direction of arrow out of inner door panel.





Replacement:
Release screws (1) and detach flat motor (2).
Tightening torque 51 35 1AZ [1][2]Rear Door Window Motor.





Important!
The power window unit must be reinitialized Testing and Inspection after it has been installed.