51 45 360 - Removing and installing/replacing wood trim on left

51 45 360 - Removing and installing/replacing wood trim on left





Special tools required:
- 00 9 321





Remove Removing and Installing/Replacing Left Fresh Air Grill (Automatic A/C High) left fresh-air grill.

Remove instrument cluster trim. This task is described 51 45 363 - Removing and installing/replacing center wood trim on instrument panel in the section "Removing center wood trim on instrument panel".





Release nut (1).

Installation:
Tightening torque, 51 45 2AZ 51 45 Trim, Instrument Panel.





Release screw (1).

With special tool 00 9 321 (fishbone) through opening for fresh air grill, unclip wood trim (3) next to retaining pin (2).

Remove wood trim (3) in direction of arrow.





Installation:
Following parts of wood trim (4) must not be damaged or missing:

1 - Shaft
2 - Speed nut
3 - Stud





Installation:
If necessary, replace damaged clip (1) (Hutfix).





Replacing clip (Hutfix):

A - Turn clip (1) with screwdriver to left by approx. 60°.
B - Lever out clip (1) from below.





Installation:
A - Insert clip (1) from above and snap into place at bottom.
Then turn clip (1) with screwdriver to right by approx. 60°.
B - Clip (1) in end position.