Sunroof / Moonroof: Adjustments

54 12 003 - Adjusting glass slide/tilt sunroof lid





Special tools required:
- 00 9 315
- 00 9 341





Close glass sunroof lid (zero position).





Ideal adjustment:

- Distance:
- Distance (A) between lid and roof at front and rear must be the same.
- Slide in special tool 00 9 341 between seal and lid. This check (sliding in and pulling out the special tool) must be subject to tightness.
- Height:
- Front - flush to 1 mm deeper
- Rear - flush to 1 mm higher

Adjustment of glass slide/tilt sunroof lid:





Remove gaiter 54 12 015 Replacing Left or Right Gaiter For Glass Slide/Tilt Sunroof on left and right.

Close sunroof lid again (zero position).

Slacken screws (1) on left/right so that sunroof lid (2) can still just be adjusted.





Height adjustment:

Adjust height of sunroof lid (1) to roof (2) with special tool 00 9 315 (gap wedge).

Press sunroof lid at front and rear up or down until ideal position is reached.





Distance setting:

Slide sunroof lid towards front/rear until ideal position is obtained.





When ideal position is obtained:

- Tighten screws (1)
Tightening torque: 54 12 2AZ 54 12 Mechanical Components of Sun Roof.
- Check function and adjustment of glass sunroof lid (2).