51 45 366 - Removing and installing/replacing wood trim on right

51 45 366 - Removing and installing/replacing wood trim on right





Special tools required:
- 00 9 321 00 9 310 Assembly Wedges (Set in Plastic Case)





Remove fresh air grill on right and in center.

Remove instrument cluster trim. This task is described 51 45 363 - Removing and installing/replacing center wood trim on instrument panel in the section "Removing center wood trim on instrument panel".





Release screws (1).





Release nut (1).

Installation:
Tightening torque, 51 45 2AZ 51 45 Trim, Instrument Panel.





With special tool 00 9 321 00 9 310 Assembly Wedges (Set in Plastic Case) (fishbone) through openings (1) for fresh air grill, unclip wood trim (2) next to retaining pin (3).





Slide threaded pin (2) with wood trim (1) out of panel (3).

Remove wood trim (1) towards rear.





Installation:
Pin (1) and threaded pin (2) of wood trim (3) must not be damaged.





Installation:
If necessary, replace damaged clips (1) (Hutfix).

No clip (Hutfix) is fitted in mounting (2).





Replacing clip (Hutfix):

A - Turn clip (1) with screwdriver to left by approx. 60°.
B - Lever out clip (1) from below.





Installation:
A - Insert clip (1) from above and snap into place at bottom. Then turn clip (1) with screwdriver to right by approx. 60°.
B - Clip (1) in end position.