Removing and Installing/Replacing EDC Control Unit

37 15 055 - Removing and installing / replacing EDC control unit





Important!
Read and comply with notes on protection against electrostatic damage (ESD protection) 61 35 ... Notes on ESD Protection (Electro Static Discharge).
Comply with notes and instructions 61 00 ... Notes on Handling Optical Fibers on handling fiber-optic cables.

After installation:
- Carry out programming/coding Programming and Relearning





Necessary preliminary tasks:
- Remove glovebox 51 16 367 - Removing and installing right glovebox (with active knee protector) with housing

- Remove fuse box from instrument panel carrier





Disconnect both plug connections (1).
If necessary, disconnect plug connections of other control units and tie up wiring assemblies.
Remove main wiring harness from A-pillar and pull a little towards rear.
Unclip EDC control unit (2) and remove towards rear.