Removing and Installing/Replacing Transversal-Acceleration Sensor

37 14 610 - Removing and installing / replacing transversal-acceleration sensor





Important!
Read and comply with notes on protection against electrostatic damage (ESD protection) 61 35 ... Notes on ESD Protection (Electro Static Discharge).





Important!
Do not kink floor panelling under any circumstances!





Necessary preliminary tasks:
- Remove right front seat
- Remove front (inside) entrance cover strip 51 47 000 - Removing and installing / replacing entrance cover strip, front (inside) left or right
- Lift floor panelling and fold back to one side





Release expansion rivets (1).
Slide air duct to one side until transversal acceleration sensor is exposed.





Release screws (1).
Tightening torque 37 14 23AZ Electric Components.
Remove transversal acceleration sensor.
Disconnect plug connection.





After installation:
- If necessary, carry out initial Dynamic Drive operation Initial Operation With Test Run of Dynamic Drive