Removing and Installing/Replacing Roller Sun Blind on Fixed Side Window of Left or Right Rear Door

51 16 400 - Removing and installing/replacing roller sun blind on fixed side window of left or right rear door





Necessary preliminary tasks:
- Disengage roller sun blind Procedures
- Remove rear door trim panel Removing and Installing Left or Right Rear Door Trim Panel





Pull out pull plate (1) from roller sun blind slightly.
Press pin (2) and remove mounting plate (3).





Release screws (1).
Lever out roller sun blind (2) at top (A) and pull out in direction of arrow (B).





Installation:
The small roller sun blind also acts as the rear guide rail of the large roller sun blind (3).
Therefore insert small roller sun blind correctly in guide (1) and brush cable (2) of large roller sun blind (3).





Installation:
Following parts on roller sun blind (3) must not be damaged or missing:
1 - Rubber mount
2 - Pull plate
4 - Sliding member





Adjusting:
If cover of roller sun blind (1) sags at edge (A) or (B), this can be corrected by turning eccentric (2).