Removing and Installing/Replacing Roller Sun Blind on Side Window of Left or Right Rear Door

51 16 405 - Removing and installing/replacing roller sun blind on side window of left or right rear door





Necessary preliminary tasks:
- Remove rear function carrier Removing and Installing Function Carrier (Without Roller Sun Blind) on Left or Right Rear Door





Disconnect plug connection (1).
Unfasten screws (2 and 3).
Unclip brush cable (4) and remove roller sun blind module.

Installation:
Tightening torque for screws (2) 51 16 10AZ [1][2][3]51 16 Mirrors, Finishers, Ashtrays, Consoles.
Tightening torque for screw (3) 51 16 11AZ [1][2][3]51 16 Mirrors, Finishers, Ashtrays, Consoles.





Release screw and remove roller sun blind from brush unit.

Installation:
Tightening torque 51 16 12AZ [1][2][3]51 16 Mirrors, Finishers, Ashtrays, Consoles.
Feed guide (1) into guide hole (2).





Turn module.
Unclip clips (A) and remove.
Unclip clip (B) (1) and pull out of guide (2).





Remove outer brush cable.

Installation:
Make sure lug (1) is seated in groove (2).





Pull roller sun blind (1) upwards slightly and remove inner brush cable (2).
If necessary, pull off chest strip (3) towards top.

Installation:
Make sure lug is seated in groove (4).





Adjusting:

Note:
If cover of roller sun blind (1) sags at line (A), this can be corrected by moving bearing (3).

Move roller sun blind (1) electrically into "top" end position.
Release screw (2) and move bearing (3) up or down until cover is taut at line (A).
Tighten screw (3).