51 16...Removing And Installing/Replacing Handbrake Lever Cover

51 16...Removing And Installing/Replacing Handbrake Lever Cover

Special tools required:
- 00 9 340

Necessary preliminary tasks:
- Apply parking brake

NOTE: Operations for removing handbrake lever cover and armrest are virtually identical. Differences can be seen in the notes on installation.







Partially fit special tool 00 9 340 as illustrated.
Unclip handbrake lever cover (2) or armrest in direction of arrow.
Force gaiter over handbrake handle.
Disconnect cable band for securing handbrake handle.
Remove handbrake lever cover (2) or armrest (1).







Installation:
Pull gaiter (1) over brake lever handle until both ends are simultaneously flush. Check that seams (4) are correctly seated.
Tighten down cable band (3).
Cable band fastener must be at lower point (2).
Cut off cable band protrusion.







Installation:
Following parts of handbrake lever cover (2) and armrest (1) must not be damaged or missing:
- Front retaining lug (5)
- Retaining lugs along line (4 or 6)
- Guides (3) of handbrake lever cover (2)







Installation:
Hook in retaining lug at front and secure handbrake lever cover (2) or armrest.