11 78 513 Replacing Both Oxygen Control Sensors

11 78 513 - Replacing both lambda oxygen control sensors (N54)





Special tools required:






Warning!
Scalding hazard!

Work should only be carried out on an exhaust system that has cooled down.





Necessary preliminary tasks:
- Remove acoustic cover Removing and Installing/Replacing Ignition Coil Cover
- Release right tie rod 32 21 231 Replacing (Removing and Installing) Left or Right Tie Rod from power steering gear

Note:
It is not necessary to conduct a chassis/wheel alignment check when the tie rod is released.





Installation Note:
If an oxygen sensor is to be reused, only apply a thin and uniform coat of Never Seez Compound (refer to BMW Parts Service) to thread.

The part of the oxygen control sensor which projects into the exhaust system branch (sensor ceramic) must not be cleaned or come into contact with lubricant.





Disconnect plug connection for oxygen control sensor, cylinders 1 to 3.

Release oxygen control sensor (1) with special tools 11 7 030 and 11 9 150.

Important!
When using special tool 11 7 030 in conjunction with special tool 11 9 150, it is essential to reduced the prescribed tightening torque by 3 Nm.

Tightening torque 11 78 1AZ Specifications.

Installation Note:
Cable colour black, cylinders 1 to 3.





Disconnect plug connection for oxygen control sensor, cylinders 4 to 6.

Release oxygen control sensor (1) with special tools 11 7 030 and 11 9 150.

Important!
When using special tool 11 7 030 in conjunction with special tool 11 9 150, it is essential to reduced the prescribed tightening torque by 3 Nm.

Tightening torque 11 78 1AZ Specifications.

Installation Note:
Cable colour grey, cylinders 4 to 6.





Assemble engine.

Check function of DME control unit.