Adjusting Rear Roof Shell

54 37 ... - Adjusting rear roof shell





Necessary preliminary tasks:
- Convertible top compartment lid Adjustments must be correctly adjusted





Open convertible top until screws are accessible.

Important!
Lock barrel screws with a flat wrench without fail.
Barrel screws on roof shell must not move out of position.

Slacken screws (1) on left and right (do not unscrew completely).





Slacken screw (1) on left and right (do not unscrew completely).





Close convertible top.
Carefully press roof shell at convertible top compartment lid.
Press roof shell until:
- a uniform gap dimension and
- lower edge parallel with convertible top cover
are obtained over the entire length.
Hold roof shell in position while screwing down.

Note:
Carry out this operation on the left and right sides in succession.





Carefully pull roofliner downwards.
Tighten down screw (1) on left and right.
Tightening torque: 54 37 06AZ 54 37 Power Convertible Top.





Tighten down screw (1) on left and right.
Tightening torque: 54 37 11AZ 54 37 Power Convertible Top.





Open convertible top until screw (1) is accessible.
Tighten down screw (1) on left and right.
Tightening torque: 54 37 06AZ 54 37 Power Convertible Top.





Adjusting pretension on fastener:

Note:
Mark position of screw.

Slacken screw (1) (do not unscrew fully).

Turn locking element upwards through 0.5 mm.
Tighten screw (1).
Tightening torque: 54 37 11AZ 54 37 Power Convertible Top.





Check gap dimensions for convertible top.
Carry out leak test Component Tests and General Diagnostics.