33 55 000 Removing and Installing/Replacing Rear Anti-Roll Bar

33 55 000 Removing And Installing/Replacing Rear Anti-roll Bar







IMPORTANT:
M3. M Coupe:
When installing the anti-roll bar, make sure the two rubber mount halves are correctly installed and correctly latched on both sides (on the retaining bracket).







Necessary preliminary tasks:
- Remove both rear coil springs.
- Remove left wishbone on wheel carrier.
- Remove both anti-roll bar links from anti-roll bar.
- Lower rear axle support.







NOTE:
To simplify the image, anti-roll bar removal is shown on the removed rear axle.
Release screws (1).
Tightening torque 33 55 1AZ.
Remove both rubber mounts from anti-roll bar.
Turn anti-roll bar (2) and remove sideways.

Installation note:
Check both rubber mounts for damage and replace if necessary.







After installation:
- Bleed brake system.