12 14 650 Replacing Suction Pressure Sensor on Intake Plenum

12 14 650 Replacing Suction Pressure Sensor On Intake Plenum (N54, N54T)







Necessary preliminary tasks:
- Read out the fault memory of the DME control unit.
- Switch off ignition.
- Remove microfilter housing.







NOTE: The installation location of the suction pressure sensor is at the rear end of the intake plenum.

Release connector (1) and remove.
Release screws and pull suction pressure sensor (2) out of housing.
Tightening torque 13 62 2AZ.







Installation note:
Check sealing ring for damage, replace if necessary.
When installing, coat sealing ring with suitable lubricant.







NOTE:
Check stored fault messages.
Delete fault memory.