51 16 211 - Removing and installing/replacing finisher for storage tray

51 16 211 - Removing and installing/replacing finisher for storage tray





Necessary preliminary tasks:
- Remove knob for controller Replacing Knob for Controller
- Remove button unit Removing and Installing/Replacing Button Unit (for On-Board Monitor)
Version with manual transmission:
- Remove gaiter Replacing Gaiter (Shift Lever Cover) for Shift Lever for gear lever
Version with automatic transmission or SMG:
- Remove finisher for preselector lever





If necessary, remove ashtray insert.
Release screws (1).
Open center console cover.
Press release button for center console cover and release trim (2) from catches (4).
Feed trim (2) towards top/rear out of storage compartment (3).
If necessary, disconnect plug connections on insert at front.
Security version:
Disconnect plug connection on intercom system switch.





Installation:
Following parts of trim (4) must not be damaged or missing:
1 - Front insert
2 - Retaining lugs
3 - Pins or spring clips

Replacement:
Remove front insert (1) 51 16 ... - Removing and installing/replacing front insert (on storage compartment trim).
Replacement with Security version:
Remove intercom system switch.