61 31 334 - Removing and installing/replacing grip trim for gear selector switch

61 31 334 - Removing and installing/replacing grip trim for gear selector switch





Special tools required:
- 00 9 322 00 9 310 Assembly Wedges (Set in Plastic Case)





Lever off side section (1) with special tool 00 9 322 00 9 310 Assembly Wedges (Set in Plastic Case) from gear selector switch (2) and remove.

Installation:
Position side section (1) on metal pins of gear selector switch (2) and uniformly press down firmly and without leaving a gap.





Lever off front shell (1) with special tool 00 9 322 00 9 310 Assembly Wedges (Set in Plastic Case) from gear selector switch (2) and remove.

Press P button (3) and remove front shell (1) starting from top.

Installation:
Insert front shell (1) at bottom in retaining ring (4). Uniformly press front shell (1) upwards onto metal pins of gear selector switch (2) firmly and without leaving a gap.





Lever off P button (1) with special tool 00 9 322 00 9 310 Assembly Wedges (Set in Plastic Case) from gear selector switch (2) and uniformly remove.

Installation:
After installing front shell, insert P button (1) into upper opening on gear selector switch and uniformly press in until it engages.