Removing and Installing/Replacing Module for Passenger Compartment Protection (Version with Panorama Glass Sunroof)
65 75 071 - Removing and installing/replacing module for passenger compartment protection (version with panorama glass sunroof)
Special tools required:
- 00 9 341
Important!
Read and comply with notes on protection against electrostatic damage (ESD protection) 61 35 ... Notes on ESD Protection (Electro Static Discharge).
Necessary preliminary tasks:
- Remove both trim panels for rear roof pillar Removing and Installing/Replacing Trim Panel for Rear Left or Right Roof Pillar (C-Pillar, Front) (C-pillars)
- Remove both trim panels for rear roof pillar (D-pillars)
- Remove both interior lights Removing and Installing/Replacing Left or Right Interior Light (Version With Panorama Glass Sunroof)
- Remove both rear grab handles 51 16 450 Removing and Installing/Replacing Rear Left/Right Grab Handle
Note:
Remove both rear and if necessary front counter supports for luggage compartment net.
Fold up cover (1).
Release screw (2) and remove counter support for luggage compartment net (3).
Lever covers (1) and (3) with special tool 00 9 341 out of roofliner (2).
Unlock catches (1) on both sides and remove sensor (2) from cover (3).
Note:
Remove second sensor in the same way.
Catches (1) and mounts (2) of cover (3) must not be damaged.
Make sure covers (3) are correctly seated in roofliner.
Disconnect wire (1) from front retaining clip.
Guide sensor through opening in roofliner.
Note:
Proceed in the same way on the second sensor.
Pull off roofliner mucket in work area.
Important!
Do not kink roofliner under any circumstances.
Unclip and lower roofliner in rear area.
Unfasten plug connection (1) and disconnect.
Open retaining lugs (2) in direction of arrow and feed out module for passenger compartment protection (3).
Disconnect wires (4) from rear retaining clips.
Remove module for passenger compartment protection (3).
Replacement:
Carry out programming/coding Programming and Relearning.