Removing and Installing/Replacing Short Range Sensor (SRR Sensor)

66 31 020 - Removing and installing/replacing short range sensor (SRR sensor)





Special tools required:
- 00 9 317 00 9 317 Trim Panel Wedge





Important!
To ensure correct SRR operation, there must be no mechanical damage (e.g. dents) to the bumper in the SRR area, nor must filler work or multilayer paintwork (more than two paint coats) have been carried out.





Necessary preliminary tasks:
- Remove front bumper trim 51 11 156 Removing and Installing Front Bumper Trim





Lever off impact absorber (1) with special tool 00 9 317 00 9 317 Trim Panel Wedge and remove.

Installation Note:
Impact absorber (1) must not be broken.

Make sure impact absorber (1) is firmly held.





Disconnect plug connection (1).

Unlock retaining tab (2) and slide out SRR sensor (3) in direction of arrow.





After installation:

Adjustment can only be carried out with the BMW diagnosis system:

Service functions:

- Chassis
- Cruise control (ACC)
- Adjust short range sensors