32 00 155 KDS Chassis/Wheel Alignment Check With Ride Height Measurement Without Vehicle Load

32 00 155 KDS chassis/wheel alignment check with ride height measurement without vehicle load





Note:
^ Read and comply with General information and definitions.
^ Read and comply with General chassis definition.
^ Update KDS data status
^ Vehicles with active steering:
Start up active steering prior to wheel alignment.





Note:
^ For vehicles with rear axle slip angle control (F01/F02/F07/F10/F11):
During measurement, move HSR actuator with BMW diagnosis system to centre position "0" (see Service function/Chassis/HSR/Wheel alignment)
^ Check compliance with test conditions, repair vehicle if necessary.
^ If the ride height is outside the tolerance range (+40/-20 mm), load or unload vehicle accordingly to adjust the vehicle in this ride height window





^ If necessary, prepare vehicle hoist.
^ Drive vehicle onto vehicle hoist.
Note: The front and rear wheels must be positioned centrally on the rotary and sliding plates.
^ Remove locking pins from both rotary and sliding plates.





Important!
Use quick-clamping holders with poly control arm bushings only.
Due to excessive measuring inaccuracy, other quick-clamping units are not permitted!





^ Attach quick-clamping holder unit to vehicle and remove clamping levers in area of front wheels
^ Attach pickup to quick-clamping holder, align using bubble level and connect to turntables





^ If necessary, attach spoiler adapter.





^ Install brake tensioner.





^ Enter customer and vehicle data
^ Identify chassis version and select vehicle
^ Enter tire inflation pressure and tread depth
^ Measure and enter vehicle ride height
If the ride height is outside the tolerance range (+40/-20 mm), load or unload vehicle accordingly to adjust the vehicle in this ride height window





^ Perform input measurement in accordance with equipment manufacturer's instructions.
^ If necessary, adjust front axle and rear axle
^ Perform output measurement in accordance with equipment manufacturer's instructions.
^ Save and print out test record.
^ Insert locking pins into both rotary and sliding plates
^ Remove wheel alignment system