32 31 102 Replacing Steering Spindle Sleeve

32 31 102 - Replacing steering spindle sleeve





Necessary preliminary tasks:
- Remove lower section of steering spindle 32 31 070 Removing and Installing/Replacing Steering Spindle Lower Section





Push steering spindle into steering column.
Pop sleeve (1) out of bulkhead, press together and remove.






Installation:
Detach pull-in lug from sleeve and lubricate gap with silicone grease.
Press sleeve together, slide onto steering column, align to opening in bulkhead and insert in bulkhead.

Note:
To prevent the sleeve from slipping out and to avoid complaints by the customer about noise, make sure that sealing lip (1) on engine compartment side rests against bulkhead all round and sealing lip (2) in inside the car rests against the damping.





After installation:
- Carry out steering angle sensor adjustment/adjustment for active front steering