Replacing Airbag Unit (Sports Steering Wheel)

32 34 030 - Removing and installing / replacing airbag unit (sport steering wheel)





Warning!
Observe the following instructions to avoid any risk of injury by the airbag unit.
- Comply with safety regulations [1][2]Safety Regulations for Handling Components with Gas Generators for handling components with gas generators.
- Do not exert any force on the airbag unit.
- Use only specified tools for releasing the airbag unit.
Note: Incorrect handling may result in triggering of the airbag unit and thereby cause serious injury.





Important!
Steering wheel Replacing Sports Steering Wheel must be replaced if airbag unit has been triggered!
Follow procedure after airbag triggering 72 12 ... Procedure After Airbag Triggering As Result of an Accident.





Necessary preliminary tasks:
- Disconnect battery negative lead Disconnecting and Connecting Battery Negative Lead





Insert Torx screwdriver (T30) horizontally into opening on reverse side of steering wheel up to stop (approx. 4.5 cm).





Increase pressure with Torx screwdriver T30 (1) on spring leg (2) until airbag unit is unlocked.
Repeat procedure on other side.

Installation Note:
Make sure electrical leads are correctly positioned.
Snap airbag unit with uniform pressing force plane-parallel in direction of steering column shaft into steering wheel.





Warning!
Danger of injury!
Airbag unit may only be set down with the airbag itself facing upwards.





Tilt airbag unit (1) slightly to one side.
Slide screwdriver (2) from front into both plug connections (3) until cover lifts off.
Disconnect plug connections (3).
Remove airbag unit (1).

Installation Note:
Connect plugs to connections of same color on airbag unit.