41 61 014 Adjusting Engine Compartment Lid

41 61 014 Adjusting Engine Compartment Lid







Do not damage adjoining body components.
Minor corrections (rework) are permitted if the existing range of adjustments are not sufficient.







NOTE:
Observe gap dimensions.
Carry over schematic diagram to the relevant vehicle type.







Check stop screw of engine compartment lid hinge on left and right.

NOTE:
Compression spring of stop screw must not be damaged or missing, replace engine compartment lid hinge if necessary.
The stop screw is preset at the factory and must not be used for adjustment.







Loosen screws (1) and (2) on left and right hinges.
Engine compartment lid lid must be able to be moved.
Tightening torque 41 61 1AZ.

NOTE:
If the adjustment range is not sufficient, release retaining screws of engine compartment lid hinge on body and move hinge.
Tightening torque 41 61 2AZ.







Adjust height to front panel by turning nut(1).

NOTE:
The strikers must snap into place in locks.
The engine compartment lid is correctly adjusted in the front section by a combination of pulling the strikers and pressing the stop pads.

Adjust stop pads.







Adjust transition of engine compartment lid to side wall by means of buffers (1) and (2).







IMPORTANT: Check function of retaining hook.







After setting:
- Tighten all screws and nuts to specified torque.
- Touch up unpainted surfaces in the appropriate colour.
- If necessary, adjust front side panels.