Air Cleaner Housing: Service and Repair

13 71 000 - Removing and installing/replacing intake filter housing (N52K)





Necessary preliminary tasks:
- Read out fault memory of DME control unit
- Switch off ignition
- Remove intake duct





Release screws (1).
Tightening torque 13 62 3AZ 13 71 Intake Silencer.
Release clamp (2) and detach air intake hose.
Tightening torque 13 62 5AZ 13 71 Intake Silencer.
Unlock plug (3) and remove.
Remove intake filter housing (4) towards top.

Installation:
Make sure intake filter housing is correctly seated on stop buffer at bottom.
Only when replacing intake filter housing, convert air-mass sensor Service and Repair.





Note:
Check stored fault messages.
Now clear the fault memory.