RPA Reset Procedure

Initialization
Initialize the RPA in the following situations:
- If tire pressure is changed
(tire pressure is corrected or reset)
- If the position of the tires is changed (change of axles, wheels), even if the tire pressure is not changed
- If a tire is changed or the wheels are interchanged
(e.g. old tires for new tires, summer tires for winter tires, etc.)
Start initialization as follows:
- Terminal 15 ON
(engine OFF or ON, do not pull away)
- Vehicles with RPA button
- Press and hold the RPA button until the RPA indicator and warning light lights up yellow for a few seconds
- Vehicles with BC button (on-board computer function)
- In the on-board computer function select "RPA" and "INIT" (LCD display) with the rocker switch on the turn-signal/main-beam switch. Press the BC button to confirm.
- Press and hold the BC button for approx. 5 seconds, until a box with a tick appears behind the "INIT" display.
> R56:
- In the on-board computer function select "SET/INFO" (LCD display in auxiliary instrument) with the BC button on the turn-signal/main-beam switch.
- Press and hold the BC button until the display changes
- Press the BC button repeatedly until the corresponding symbol and the word "RESET" are displayed.
- Press and hold the BC button until a square with a tick appears.
- Vehicles with Central Information Display
Initialization is performed via the Central Information Display (CID) and controller.
- Select "RPA" in the "Settings" menu and confirm.
- Select "Set" and confirm.
- Drive off
The end of the initialization phase is not indicated.