Reference to Functional Description (AFS)

Reference To Functional Description (AFS)


Diagnosis instructions
Commissioning/aligning of the active steering is necessary during or after the following work:
- axle adjustments
- After work on the steering column
- after replacing or programming the active steering control unit
- after replacing or programming the steering column switch cluster (SZL): E60/61/63/64
- after replacing the steering column switch cluster (SZL): E90/91, E87
- after replacing or programming the Dynamic Stability Control (DSC)
- on adjustment of the steering angle sensor
- After replacing the steering box

Here, select the service function Commissioning/aligning active steering and work through it (automated operation).
The function can be found at the following path: Service functions/Chassis and suspension/Active steering Angular range of the cumulative steering angle sensor
The steering movements permit the following angular ranges of the total steering angle: E60/61: ± 506 degrees E63/: ± 526 degrees

With increased steering momentum, the total steering angle can be slightly enlarged. If the vehicle is on the ground with the engine running (full power-assisted steering), the angular range at normal steering momentum for the E60/61 is approx. ± 500 degrees.

General information
The voltage supply of the vehicle was interrupted by disconnecting the battery or deactivating the battery master switch.
Procedure for activating the active steering without the BMW diagnosis system.
- Connect the battery or activate the battery master switch
- Start the engine. The following Check Control message appears: active steering inactive
- Move the steering wheel once to the left-hand limit position and once to the right-hand limit position (alternatively, the vehicle can be driven at approx. 30 - 40 kph)
- Switch off the engine, switch off terminal 15
- Start the engine; the active steering is now once again fully functional
The fault memory of the active steering control unit must be deleted, as at least one fault entry is still present. This fault entry is caused by the invalid message regarding the steering angle sensor after the first engine start.