65 24 020 Removing and Installing/Replacing Blocking Circuit

65 24 020 - Removing and installing or replacing blocking circuit





Important!
Read and comply with notes on protection against electrostatic damage (ESD protection) 61 35 ... Notes on ESD Protection (Electro Static Discharge).





Necessary preliminary tasks:
- Remove both trim panels for roof pillars at rear Removing and Installing/Replacing Trim Panel For Left or Right Rear Roof Pillar (C-Pillar)
- Remove rear left interior light 63 31 015 Removing and Installing/Replacing Left or Right Interior Light (Side Roofliner)
- Remove rear left grab handle 51 16 450 Removing and Installing/Replacing Rear Left/Right Grab Handle





Important!
Do not kink roofliner under any circumstances!

Pull off muckets of rear lid and rear doors in roof area.
Unclip roofliner (1) in middle area downwards and lower.

Installation Note:
Holder (2) for roofliner (1) must be replaced.





Version with dividing net mounts (1):
Fold back cover (2) for dividing net mount (1).
Release screw (3) and remove dividing net mount (1).

Installation Note:
Observe position indications on reverse side of dividing net mount (1).





Note:
For purposes of clarity, following graphics show roofliner removed.

Release screw (1), slacken screw (3) and turn countersupport holder (2) back in direction of arrow.





Disconnect plug connection (1, 2).
Unfasten screw (3) and remove blocking circuit.






Installation Note:
Align blocking circuit to body by way of screw and positioning pin.