13 62 560 Removing and Installing/Replacing Hot Film Air Mass Meter

13 62 560 Removing And Installing/replacing Left Or Right Air-mass Flow Sensor (N63)







Necessary preliminary tasks:
- Read out fault memory of DME control unit
- Turn off ignition
- Remove acoustic cover







Picture shows the left side, the procedure for the right side is identical.
Unlock plug (1) and remove.
Unfasten screws (2).
Tightening torque 13 62 6AZ.
Pull air-mass flow sensor (3) out of upper section of intake filter housing.

Installation:
Replace gasket on air-mass flow sensor.







NOTE:
Check stored fault message.
clear fault memory.