Securing Engine In Installation Position

11 00 670 Securing engine in installation position (N74)

Special tools required:





Warning!
Risk of injury!
Observe following instructions relating to special tool:
1. Prior to each use, check the special tools for defects, modifications and operational reliability.
2. Damaged/modified special tools must not be used!
3. No changes or modifications may be made to the special tools!
4. Keep special tools dry, clean and free of grease.





Note:
^ Numbering system for special tools has been re-encoded.





Important!
Special tool 00 6 000 must not be fitted when transverse member (1) is installed!





Necessary preliminary tasks:
^ Secure engine compartment lid in service position
^ Remove panel for engine compartment lid at side
^ Remove acoustic cover
^ Remove front underbody protection





Assemble transverse member 00 6 000 with special tools 00 6 002 00 6 004, 00 6 010, 00 6 050.





Note:
Contact points (1) for special tool 00 6 050 are pictured.





Important!
Risk of damage!
Position transverse member 00 6 000 with a 2nd person helping on contact points ().

Secure suitable chain (1) on the spindle 00 6 002.





Suspend chain on the front suspension lug (1) of the engine.





Important!
Avoid a change of engine position in the transverse or longitudinal direction.
Always make sure there is sufficient clearance between the engine (or its attachment parts) and the body.





Warning!
Risk of injury!
Tighten down all screws and nuts on transverse member 00 6 000.





Release screws (1).

Tightening torque 22 11 1AZ.

Raise engine approx. 10 mm with transverse member.

$��: