Wiper Motor: Service and Repair

61 61 270 - Removing and installing/replacing bracket for windscreen wiper system complete with motor





Necessary preliminary tasks:
- Remove both wiper arms Service and Repair
- Remove lower section of microfilter housing
- Remove cowl panel cover 51 13 116 Removing and Installing Cowl Panel Cover
- Remove both tension struts from spring strut dome





Release screws (2) from left heater bulkhead (3).
Remove left heater bulkhead (3) towards top.
Unclip cable (1) for wiper motor from holder.
Release screws (5) for wiper bracket (4).
Tightening torque, 61 61 6AZ 61 61 Windshield Wipers.
Remove wiper bracket (4) upwards.
Disconnect plug for wiper motor.






Installation:
Rubber mount (1) and rubber guide (3) must not be missing.
Rubber guide (3) must be correctly seated in guide (2).





Installation:
Before fitting the wiper arms, allow the windscreen wiper motor to run into the rest position.
To ensure that the windscreen wiper system functions properly, check/adjust 61 61 ... Adjusting Left or Right Windscreen Wiper the contact angle of the wiper arms to the windscreen.