Removing and Installing/Replacing Front Underbody Protection

51 47 490 - Removing and installing / replacing front underbody protection





Warning!
Scalding hazard!
Only perform work after engine has cooled down.





Release screws (1 and 2).





Release screws (1 and 2) on both sides.
Remove tip of engine compartment shield (3) on left/right.

Installation Note:
Make sure tip of engine compartment shield (3) is installed in correct position.





Warning!
Danger of burning on oil line!

Turn catch (1) on cable through 90° and disengage in direction of arrow from bracket (2) on both sides.
Pull underbody protection (3) forwards under bumper trim and remove.

Installation Note:
Centre underbody protection (3).





Replacement:
- Modify sheet nuts

Installation Note:
If necessary, replace faulty metal nuts.