Adjusting Engine Bonnet/Hood

41 61 014 Adjusting Engine Bonnet/Hood







IMPORTANT:
Do not damage adjoining body parts.
Minor corrections (realignment work) are permitted if the existing adjustment options are not sufficient.







NOTE:
Observe gap dimensions.
Carry over schematic representation to the relevant vehicle type.

Slacken nuts (1) of hinges on left and right.
Hood lid must be able to be moved.
Tightening torque 41 61 1AZ.







NOTE: If the adjustment range is not sufficient, release retaining screws of engine hood hinge on body and move hinge.

Tightening torque 41 61 2AZ.







Retaining hooks must snap into place in locks.
Adjust engine hood.

NOTE: Vertical adjustment of engine hood to side panel by means of stop pads.







NOTE: Adjust height of hood/bonnet to front bumper by turning nuts (1) on retaining hooks.

If adjustment is necessary, remove front grille.







Do not slacken nut (2).
Adjust hood/bonnet by turning spacers (1) on both sides.







IMPORTANT: Check function of retaining hook.







After installation:
- Tighten all screws and nuts to specified torque.
- Touch up unpainted surfaces in the appropriate colour.
- If necessary, adjust front side panels.