Coolant: Service and Repair
17 00 005 Draining and adding coolant (N52K)Special tools required:
Warning!
Risk of scalding!
This repair work on the cooling system should only be carried out on an engine that has cooled down!
Important!
Lifetime coolant filling:
Never reuse used coolant!
When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be drained and refilled.
In the case of other removal work involving the draining of partial quantities of coolant, replace these quantities which have been drained with new coolant.
Installation Note:
Use only recommended coolant.
Observe mixture ratio.
Protective measures/rules of conduct:
^ Wear safety goggles
^ Wear protective gloves
^ Observe national/country-specific regulations
Important!
For dirt contamination of the cooling system (e.g. by engine oil), the cooling system must be rinsed with water until all dirt contamination is removed!
Important!
Risk of skidding due to coolant on the floor.
Danger of injury!
Catch and dispose of drained coolant in drip tray (1) and if necessary special tool 00 2 030 (universal hydraulic lifting equipment).
Recycling:
Observe country-specific waste disposal regulations.
Necessary preliminary work:
^ Follow notes for repair work on the cooling system
^ Remove underbody protection
^ Remove reinforcement plate
Draining coolant:
Open the sealing cap (1) on coolant expansion tank (2).
Installation Note:
Close the sealing cap (1) until the arrow marks line up.
If fitted, unfasten coolant drain plug (1).
Drain, catch and dispose of coolant.
Installation Note:
^ Replace sealing ring.
^ Tightening torque 17 11 2AZ.
Release clamp and detach coolant hose (1).
Catch and dispose of escaping coolant.
Note:
Adding coolant:
Use only recommended coolant.
Observe capacities.
Observe mixture ratio.
Observe bleeding instructions without fail.
Fill and bleed cooling system.
Check cooling system for leaks.
