Campaign - ICM Anti-Rattle Damper Installation

SI B 61 14 09
General Electrical Systems

September 2009
Technical Service

PERFORM THE PROCEDURE OUTLINED IN THIS SERVICE INFORMATION ON ALL AFFECTED VEHICLES THE NEXT TIME THEY ARE IN THE SHOP FOR MAINTENANCE OR REPAIRS AND PRIOR TO RETAIL DELIVERY.

SUBJECT
Service Action: Install ICM Anti-Rattle Damper

MODEL
E70 (X5 M)
E71 (X6 M)

SITUATION
The vehicle B+ cable may contact the holder for the ICM (Integrated Chassis Management) and this can cause rattling noises. The ICM is located in the trunk.

AFFECTED VEHICLES
This Service Action involves E70 (X5 M) and E71 (X6 M) vehicles which were produced from June 15, 2009 to August 17, 2009.

In order to determine if a specific vehicle is affected by this Service Action, it will be necessary to utilize the "Service Menu" of DCSnet (Dealer Communication System) or the Key Reader. Based on the response of the system, either proceed with the corrective action or take no further action.

PROCEDURE

See attachment "B611409 Repair procedure" shown at the bottom of this bulletin.





PARTS INFORMATION

LABEL INSTRUCTIONS

This Service Action has been assigned code number 550. After the vehicle has been checked and/or corrected, obtain a label (SD 92-366) and:

A. Emboss your BMW center warranty number in the middle of the label (1);

B. Punch out code number 550 (2), printed on the label; and





C. Affix the label to the B pillar as shown.

If the vehicle already has a label from a previous Service Action/Recall Campaign, affix the new label next to the old one. Do not affix one label on top of another one because a number from an underlying label could appear in the punched-out hole of the new label.





WARRANTY INFORMATION
Covered under the terms of the BMW New Vehicle Limited Warranty.





Attachment - B611409 Repair Procedure