Cowl: Service and Repair

51 71 ... Removing And Installing/Replacing Assembly Compartment Partition Wall







Necessary preliminary tasks:
- Remove left microfilter housing cover
- Remove microfilter housing (upper section)







Assembly compartment partition wall, middle:
Remove seal (1) for engine hood/bonnet.
Release screws (2, 4).
Remove partition wall (3).

Installation:
Make sure partition wall is correctly positioned.







Equipment compartment partition wall, left:
Release expansion rivet (1).
Release screws (2, 4).
Left only: Unclip connecting cable (3).
Remove partition wall (5).

Installation:
Replace damaged expander rivet.
Make sure partition wall is correctly positioned.
Make sure screws are installed in correct positions.







Equipment compartment partition wall, right:
Release clip (1).
Unfasten screws (2).
Remove partition wall (3).

Installation:
If necessary, replace faulty clip (1).
Make sure partition wall is correctly positioned.
Make sure screws are installed in correct positions.