Sunroof / Moonroof: Adjustments

54 12 003 Adjusting Glass Slide/Tilt Sunroof Panel

Special tools required:







Close slide/tilt sunroof panel (zero position).







Ideal adjustment:
- Distance:
- Distance (A) between lid and roof at front and rear must be the same.
- Insert special tool 00 9 341 between seal and lid. This check sliding in and pulling out the special tool) must be subject to tightness

- Height:
- Front - flush to 1 mm deeper
- Rear - flush to 1 mm higher







Adjusting the glass tilting/sliding roof panel:
Remove gaiter on left and right.
Close slide/tilt sunroof lid again (zero position).
Slacken screws (1) on left/right so that slide/tilt sunroof lid (2) can still just be adjusted.







Height adjustment:
Adjust height of glass tilting/sliding roof panel (1) to roof (2) using special tool 00 9 315 (gap dimension wedge).
Press slide/tilt sunroof lid at front and rear up or down until ideal position is reached.







Distance setting:
Slide glass slide/tilt sunroof lid towards front/rear until ideal position is obtained.







When the ideal setting is reached:
- Tighten screws (1).
Tightening torque: 54 12 2AZ.
- Check function and adjustment of glass slide/tilt sunroof lid (2).