Removing and Installing/Replacing Left or Right Rear Light (In Side Panel)

63 21 180 - Removing and installing/replacing left or right rear light (in side panel)





Important!
Read and comply with notes on protection against electrostatic damage (ESD protection) 61 35 ... Notes on ESD Protection (Electro Static Discharge).





Necessary preliminary tasks:
- Remove socket housing for rear light Replacing a Socket Housing for Left or Right Rear Light (Side Panel)





Release nuts (1, 3), gripping the threaded pin with a suitable tool in so doing. Tightening torque 63 21 1AZ Mechanical Specifications.
Remove rear light (4) in outwards direction from side panel (5).

Installation Note:
- Observe tightening sequence:
1. Tighten nuts (3)
2. Tighten nut (1)
- Make sure spacer (2) is correctly seated on side panel (5)
- Make sure sealing washers are fitted on threaded pins between rear light (4) and side panel (5)
- Make sure sealing frame for rear light Replacing Sealing Frame for Left or Right Rear Light (on Side Panel) is correctly seated on rear light (4)
- Make sure gap is uniform all round between rear light (4) and side panel (5).