31 12 090 Removing and Installing/Replacing Both Compression Struts

31 12 090 Removing and installing/replacing left or right leading link (AWD)

Special tools required:







NOTE: If the leading link is detached from the front axle support, it is necessary after installation to carry out a wheel alignment.







Necessary preliminary tasks:
- Remove guide joint from swivel bearing
- If necessary, remove reinforcement cover







Slacken nut (1).
Tightening torque 31 12 5AZ.
Remove screw (2) to one side and remove leading link (3) with guide joint.

Installation note:
Replace self-locking nut.
Tighten bolt connection in normal position.







If necessary, screw nut (1) onto guide joint by a few turns.
If necessary, replace lower section 31 2 242 with lower section31 2 246
31 2 240Press guide joint with special tool out of leading link.
Unscrew nut (1) and remove guide joint.

Installation note:
Keep journal on guide joint and bushing in leading link clean and free from oil and grease.







After installation:
- Perform chassis / wheel alignment check
- Carry out steering angle sensor adjustment

�~*:

�w|*:

�*: