33 32 180 Removing and Installing/Replacing Left or Right Toe Arm

33 32 180 Removing and installing/replacing left or right toe arm





Note:
If the toe arm is detached from the rear axle support, it will be necessary to carry out a wheel alignment procedure after assembly.





Necessary preliminary work:
^ Remove rear wheel.

F01, F02:

Release nut (1) and remove heat shield (2).

Tightening torque 33 32 10AZ.

Installation note:





Replace self-locking nut.





F10, F11:

Remove cable holder (1) on toe arm.

Installation note:
If necessary, replace faulty cable holders.





Release screw (1).

Tightening torque 33 32 6AZ.

Pull out bolt (1) and remove toe link (2).

Installation note:
Tighten down bolt connection in normal position.

Slacken nut (1).





Tightening torque 33 32 7AZ

Remove toe link (2) from wheel carrier.

Installation note:
Insert toe link (2) first in wheel carrier.

Keep toe link to wheel carrier connection clean and free from oil and grease.

Replace nut.





After installation:
^ Carry out wheel alignment procedure.

�~����: