54 13 003 Adjusting Glass Slide/Tilt Sunroof Lid

54 13 003 Adjusting Glass Slide/tilt Sunroof Lid







Special tools required:
- 00 9 315
- 00 9 340







Necessary preliminary tasks:
- Close glass slide/tilt sunroof completely

If the glass slide/tilt sunroof is outside the adjustment tolerances, adjust as follows:







Installation:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use







Adjusting glass slide/tilt sunroof cover at front:

Carry out the following step on one side first and then the other (first left, then right or vice versa):
- Insert Torx screws (1) on left/right so that glass slide/tilt sunroof cover can still just be adjusted
- Partly open glass slide/tilt sunroof cover and close again, glass slide/tilt sunroof cover moves into position
- Adjust height of glass slide/tilt sunroof cover (see below)
- Tighten down all screws to tightening torque 54 12 01AZ.
- Repeat procedure on other side.







Height adjustment, glass cover, front:
Check height of glass cover (1) in relation to body (2) with special tool 00 9 315.
Press glass lid (1) at front and rear towards top or bottom until ideal position is reached.

Height:
- Front edge of glass cover at front 0.9 mm under roof edge
- Rear edge of glass cover at front 0.9 mm over glass cover at rear







Height adjustment, glass cover, rear:
Glass cover must be firmly secured to body with screw (1).
Tightening torque 54 12 05AZ.
Check height of glass cover (1) in relation to body (2) with special tool 00 9 315.

Height:
- Rear edge of glass cover at front 0.9 mm over glass cover at rear
- Rear edge of glass cover at rear 0.9 mm over roof edge

Adjust height with external hexagon (2).







Gap setting:
The cover assumes gap A between the body and front glass cover which should be set evenly all round.
Gap A between the body and rear glass cover is defined by the fixed installation position with alignment tool.
Check same gap of glass lid and body with special tool 00 9 340.
Slide special tool 00 9 340 or similar between seal and insert. It must be possible to slide the card against the same level of resistance.
Check function and adjustment.