54 13 003 Adjusting Glass Slide/Tilt Sunroof Cover

54 13 003 Adjusting Glass Slide/Tilt Sunroof Cover

Special tools required:







NOTE: Make the adjustment with an assistant.

Necessary preliminary tasks:
- Close glass slide/tilt sunroof completely

If the glass slide/tilt sunroof is outside the adjustment tolerances, adjust as follows:







Installation note:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of hardening)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use







Adjusting glass slide/tilt sunroof cover at front:
Carry out the following step on one side first and then the other (first left, then right or vice versa):
- Insert Torx screws (1) on left/right so that glass slide/tilt sunroof cover can still just be adjusted
- Partially open and then close glass slide/tilt sunroof cover, sunroof lid floats settles into position
- Adjust height of glass slide/tilt sunroof cover (see below)
- Tighten screws to tightening torque 54 12 01AZ
- Repeat procedure on other side.







Height adjustment, glass lid, front:
Check height of glass cover (1) in relation to body (2) with special tool 00 9 315.
Press glass lid (1) at front and rear towards top or bottom until ideal position is reached.

Height:
- Front edge of glass lid at front 0.9 mm under roof edge
- Rear edge of glass lid at front 0.9 mm over glass lid at rear







Height adjustment, glass lid, rear:
Glass lid must be firmly secured with screws (1) to body.
Tightening torque 54 12 05AZ.
Check height of glass cover (1) in relation to body (2) with special tool 00 9 315.

Height:
- Rear edge of glass lid at front 0.9 mm over glass lid at rear
- Rear edge of glass lid at rear 0.9 mm over roof edge

Carry out height adjustment via hexagon insert bit (2).







Distance setting:
Distance A between body and front glass lid settles into position and should be evenly set all round.
Distance A between body and rear glass lid is determined by means of a fixed installation position with alignment tool.
Check that distance between glass slide/tilt sunroof covers and body is the same with special tool 00 9 340.
Slide special tool 00 9 340 or similar between gasket and insert. It must be possible to slide the card against the same level of resistance.
Check function and adjustment.