Resetting Service Interval Indicator (Alternate In-Car Method)

CBS Reset

Important!
The CBS maintenance jobs can be reset in the car. It is always recommended to reset the CBS jobs via the diagnosis system. It is only possible to code the statuatory intervals specific to individual countries with the diagnosis system.


CBS Reset in Car

The service jobs can be reset in the car at the instrument cluster.

NOTE:
A reset is only possible in the car if:
- there is no Check Control message
- availability of the service job is under 90%
- on-board date must be correctly set

Resetting of a service job must always be carried out after a maintenance measure has been completed.
The resetting procedure is aborted by a timeout or a terminal change.

Important!
If engine oil and vehicle check are reset at the same time, always reset oil first.

Switch on ignition.






Press the trip odometer reset button (1) (referred to as button in the following) for approx. 10 seconds until the 1st service job appears in the display (2).

Bring up the next item by briefly pressing the button again. Select desired service job.






If a reset is possible, this is displayed in the instrument cluster as "Reset Executable" (1).

Start the reset by pressing the button for 3 seconds.






Confirm text message "Execute Reset?" (1) by pressing the button for 3 seconds again.






The status of the reset is indicated in the display by a progress bar and in text as "Reset Running" (1).






The reset is confirmed after completion as "Reset Sucessful" (1).

CBS Reset of Inspection/Tests Required by Law






Input the target for the inspections/tests required by vehicle/emissions by clicking on the job with the CBS menu of the Control Display at:

- Press controller to call up i menu

- Select Info Sources and press controller

- Select Service and press controller

- Select Service Requirements and press controller

- Select Stat, vehicle insp. and press controler

- Select Satus and press controller

- Select Schedule Date for Service and press controller

- The target month or the target year can be set acknowledged by turning or pressing.