Removing and Installing/Replacing Sensor For Lane Departure Warning (HC2 Sensor)

66 32 ... - Removing and installing/replacing sensor for Lane Departure Warning (HC2 sensor)





Necessary preliminary tasks:
- Remove rear bumper trim





Disconnect plug connection (1).
Release screws (2).
Remove HC2 sensor (3).





Important!
If, in the event of side damage to the vehicle, it is not necessary to replace the rear apron, observe the following points:

Mount middle bumper trim guide on undamaged side

Use middle bumper trim guide as a gauge in order to check or correct the position of the remaining connecting points.

Middle bumper trim guide must be able to be installed without tension.





Replacement:
- Carry out vehicle programming and coding Programming and Relearning.





Replacement/after body repair:
-> Execute diagnosis job
- Initial operation
- SWW sensor system