61 35 127 Removing and Installing/Replacing Body Gateway Module

61 35 127 Removing And Installing/replacing Body Gateway Module







IMPORTANT: Read and comply with notes on protection against electrostatic discharge (ESD protection).







Read out programming/encoding.
- Print out and make a note of settings for Car & Key Memory in CKM menu







Necessary preliminary work:
- Disconnect negative battery cable
- Disconnect both negative battery cables at F03
- Remove trim panel for pedal mechanism







Disconnect plug connection (1).
Release screw (2) and remove cable shoe (4).
Tightening torque 61 35 3AZ.
Pull body module (3) out of equipment holder (5) in direction of arrow.

Installation note:
Make sure body module (3) is correctly installed in equipment holder (5).







Replacement:
Carry out programming/encoding.

Perform FlexRay synchronization via path:
- Body
- Central Gateway Module
- Initialize FlexRay

Check printed-out or noted-down settings for car and key memory in CKM menu and reset if necessary