Removing And Installing/Replacing Pressure Lines For Oscillating Motor Fa2

37 13 125 - Removing and installing/replacing pressure lines for oscillating motor FA2





Special tools required:
- 32 1 270





Warning!
Danger of poisoning 00 .. ... Danger of Poisoning If Oil Is Ingested/Absorbed Through the Skin if oil is ingested/absorbed through the skin!

Risk of injury 00 .. ... Risk of Injury If Oil Comes Into Contact With Eyes and Skin if oil comes into contact with eyes and skin!

Important!
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.

Do not draw off hydraulic fluid (risk of contamination).

Seal off line connections with plugs 32 1 270 .





Recycling:
Catch and dispose of hydraulic fluid in a suitable container.





Necessary preliminary tasks:
- Remove front right wheel arch cover
- Lower front axle 31 11 506 Lowering/Raising Front Axle Support (Universal Lifter)





Important!
Pressure line and connection on valve block must be fitted with suitable sealing plugs 32 1 270 immediately after removal!





Unfasten screw fitting (1).

Tightening torque 37 13 5AZ 37 13 Hydraulic Lines.





Release screws (1) from line holder on front axle carrier and remove holder.

Tightening torque 37 13 7AZ 37 13 Hydraulic Lines.





Unlock plastic holder (1) and disengage line.





Release screw (2).

Remove pipe.

Tightening torque 37 13 4AZ 37 13 Hydraulic Lines.





Important!
Note installation position of rubber spacer (1).

Make sure pressure lines are laid without tension.





Important!
When assembling, make sure that in succession only the sealing plugs of the line to be fitted are removed.

When fitting lines, do not tilt connectors (sealing rings!) and connect fully before screwing.

Do not replace sealing rings on hydraulic lines.

Replace affected line if sealing ring is damaged.





After installation:

- Fill and bleed hydraulic system 32 13 006 Bleeding Power Steering (Version With Dynamic Drive)
- Check line connections for leaks
- Carry out initial Dynamic Drive operation 37 10 001 Initial Operation With Test Run of Dynamic Drive.